[?] A summary of the violations found during the inspection are listed below.

3717-1-04.5(A)(1) / Cleanliness of equipment food-contact surfaces and utensils.
Critical Corrected During Inspection Equipment food-contact surfaces or utensils are unclean. Observed a stored thermometer immediately placed into the internal monitoring recording of the TCS food without the step of proper sanitation. Note: corrected during inspection.

3717-1-02.4(A)(2) / PIC - Manager Certification
Facility does not have an employee with manager certification in food protection. Properly provide an employee with manager ODH certification in food protection. Note: management informed sanitarian this is in the process to soon be completed.
Correct By: 17-Feb-2023
3717-1-06.1(A) / Floors, walls, and ceilings.
Floors, walls, and/or ceilings not smooth and easily cleanable. Observed a floor area missing floor tile located by the rear handwashing sink.
Correct By: 17-Feb-2023
3717-1-06.4(A) / Repairing.
Physical facilities not maintained in good repair. Observed one non-working hood light located above the cooking equipment. repair to properly restore the observed non-working hood light which is located above the cooking equipment.
Correct By: 17-Feb-2023
3717-1-06.4(B) / Cleaning - frequency and restrictions.
Facility not maintained clean. Observed build-up on the floor located along the wall by the rear of the cooking equipment. remove the observed build-up from the floor which is located along the wall by the rear of the cooking equipment.
Correct By: 17-Feb-2023
3717-1-06.4(B) / Cleaning - frequency and restrictions.
Facility not maintained clean. Observed build-up on the hood vent covers located above the cooking equipment. remove the observed build-up from the hood vent covers.
Correct By: 17-Feb-2023


Inspection Information


Facility Type: Commercial FSO < 25000 sq. ft.

[?] Inspection Type: Standard/Critical Control Point

Inspection Date: 07-February-2023


Comments
Note: Prevent Pest exterminating performs the monthly exterminating application. The contact phone number is: 440-322-0870
CRITICAL CONTROL POINT INSPECTION
IV - Demonstration of Knowledge: The Person in Charge (PIC) did not comply with this chapter by having no critical violations during the current inspection. To comply with this Chapter and exercise active managerial control over the facility, the PIC shall have no critical violations during the current inspection, which decreases opportunities for foodborne illness outbreaks. The Inspector reviewed with the PIC the chapters in the Code where the critical violations are addressed. In addition, the Inspector educated the PIC on the public health significance of each critical violation. Finally, the Inspector outlined ways to prevent critical violations during future inspections
VII - Protection from Contamination: Foods need to be protected at all times from physical and environmental contamination during storage, preparation, holding and display. Observed a stored thermometer immediately placed into the internal monitoring recording of the TCS food, shredded cheese at 41°F, without the step of proper sanitation. Discussed with staff of good processes of sanitizing the digital probe thermometer prior to the internal temperature check. Providing adequate air contact drying time for the wiping cloths in a sanitizer solution or alcohol wipes is a good preventitive of potential cross-contamination which can cause a foodborne illness.

X - P - Chemical: Toxic materials are properly identified and stored.
VI - P - TCS Food: Observed ready to eat TCS foods being properly date marked, and discarded when required. Sanitarian informed staff TCS foods being properly date marked, and discarded when required is a good preventitive in the growth of organisms which can cause a foodborne illness.


Inspection Outcome: