[?] A summary of the violations found during the inspection are listed below.

3717-1-04.8(E)(2) / Clean equipment and utensils stored in a self-draining position and covered or inverted.
Clean equipment and utensils not stored in a self-draining position and covered or inverted. Observed not all clean utensils not stored in a self-draining position and covered or inverted. properly provide all clean utensils, primarily stored ladles, in a self-draining position and covered or inverted.
Correct By: 14-May-2023
3717-1-04.4(A)(2) / Equipment components kept intact, tight, and adjusted
Equipment components are not intact, tight or properly adjusted. Observed the walk-in cooler door seal partially not intact, tight or properly adjusted. rpair to properly restore the walk-in cooler door seal which is partially not intact, tight or properly adjusted.
Correct By: 14-May-2023
3717-1-06.4(A) / Repairing.
Physical facilities not maintained in good repair. Observed the handwashing sink missing a wall seal located by the dishwasher equipment. repair to properly restore the observed handwashing sink which is missing a wall seal located by the dishwasher equipment.
Correct By: 14-May-2023
3717-1-06.4(B) / Cleaning - frequency and restrictions.
Repeat Facility not maintained clean. Observed build-up on the ceiling vent cover located in the warewashing area. remove the observed build-up from the ceiling vent cover which is located in the warewashing area.
Correct By: 30-Apr-2023
3717-1-06.1(A) / Floors, walls, and ceilings.
Floors, walls, and/or ceilings not smooth and easily cleanable. Observed the floor missing material located by the dishwasher equipment. repair to properly restore the observed the floor missing material located by the dishwasher equipment.
Correct By: 07-May-2023


Inspection Information


Facility Type: Commercial FSO < 25000 sq. ft.

[?] Inspection Type: Follow-up

Inspection Date: 04-May-2023


The following violation(s) have been corrected since the last inspection.
Comments
Observed no critical code violation at the time of re-inspection.


Inspection Outcome: