[?] A summary of the violations found during the inspection are listed below.

3717-1-02.4(B)(1) / PIC: Demonstration of Knowledge - No Critical Violations
Critical PIC unable to demonstrate knowledge by having no critical violations.

3717-1-04.5(A)(1) / Cleanliness of equipment food-contact surfaces and utensils.
Critical Corrected During Inspection Equipment food-contact surfaces or utensils are unclean.OBSERVED MIXER IN BAKERY HAS OLD FOOD DEBRIS ON IT . IN ORDER TO REDUCE THE RISK OF CROSS CONTAMINATION ALL FOOD CONTACT SURFACES MUST BE CLEANED AND SANITIZED BEFORE AND AFTER USE. CORRECTIVE ACTION: MIXER WAS CLEANED DURING INSPECTION

3717-1-03.4(G) / Ready-to-eat, time/temperature controlled for safety food - date marking.
Critical Corrected During Inspection Refrigerated, ready-to-eat, TCS foods not properly date marked.OBSERVED HAM AND TURKEY IN DELI CASE WAS NOT DATE MARKED. IN ORDER TO REDUCE THE RISK OF A FOOD BORNE ILLNESS ALL TSC FOOD HELD OVER 24 HOURS MUST HAVE PREP DATE AND MUST BE DISCARDED WITHIN 7 DAYS. CORRECTIVE ACTION FOOD WAS DISCARED

3717-1-06.1(M) / Outer openings - protected.
Outer opening not protected.OBSERVED DOOR SWEEP ON ROLL DOOR IN STORAGE AREA NEEDS TO BE EXTENDED TO PREVENT PEST FROM ENTERING.

3717-1-04.3(B) / Fixed equipment installation - spacing or sealing.
Fixed equipment not properly sealed or spaced for cleaning.OBSERVED GASKET SEAL ON FREEZER DOOR ( SEA PAK FOOD) HAS BECOME DETACHED

3717-1-04.4(B) / Cutting surfaces.
Cutting blocks or boards cannot be effectively cleaned and sanitized.OBSERVED CUTTING BOARD IN THE DELI AREA IS SERVERELY SCORED

3717-1-04.3(B) / Fixed equipment installation - spacing or sealing.
Repeat Fixed equipment not properly sealed or spaced for cleaning.OBSERVED THREE COMPARTMENT SINK IN MEAT ROOM HAS BECOME DETACHED FROM THE WALL

3717-1-06.4(B) / Cleaning - frequency and restrictions.
Facility not maintained clean.OBSERVED FLOORING UNDERNEATH EQUIPMENT AND SINK IN HOT FOOD AREA IS DIRTY


Inspection Information


Facility Type: Commercial RFE ≥ 25000 sq. ft.

[?] Inspection Type: Standard/Process Review

Inspection Date: 18-December-2021


Comments
OPERATION NO LONGER PERFORMING PROCESS REVIEW ACTIVITIES


Inspection Outcome: