3717-1-04.4(A)(2) / Equipment components kept intact, tight, and adjusted
Repeat Equipment components are not intact, tight or properly adjusted.RUBBER GASKET SEAL NEEDED.
Equipment components such as doors, seals, hinges, fasteners, and kick plates shall be kept intact, tight, and adjusted in accordance with manufacturer's specifications.
3717-1-05.4(N) / Covering receptacles.
Observed waste receptacles that were not covered.
Receptacles and waste handling units for refuse, recyclables, or returnables shall be: kept covered inside the FSO or RFE if they contain food residue and are not in continuous use, and after they are filled; or with tight-fitting lids or doors if kept outside.
3717-1-05.4(P) / Maintaining refuse areas and enclosures.
Repeat Observed an improperly cleaned storage area for refuse, recyclables, or returnables.
A storage area and enclosure for refuse, recyclables, or returnables shall be maintained clean and free of unnecessary items.
3717-1-06.1(I) / Light bulbs - protective shielding.
Repeat Observed light bulbs or heat lamp that were not properly shielded or coated where required.
Light bulbs shall be shielded, coated, or otherwise shatter-resistant in areas where there is exposed food, clean equipment, utensils, or linens, or unwrapped single-service or single-use articles and does not apply in areas used only for storing food in unopened packages. An infrared or other heat lamp shall be protected against breakage by a shield surrounding and extending beyond the bulb so that only the face of the bulb is exposed.