[?] A summary of the violations found during the inspection are listed below.

3717-1-03.4(G) / Ready-to-eat, time/temperature controlled for safety food - date marking.
Critical Corrected During Inspection Observed refrigerated, ready-to-eat, TCS foods held refrigerated for more than 24 hours were not properly date marked at time of inspection (hot dogs).
To prevent foodborne illness, refrigerated, ready-to-eat, TCS food held at a temperature of 41°F or less for more than 24 hours shall be clearly marked at the time of preparation or the time the original container is opened to indicate the date or day, that is a maximum of seven days, by which the food shall be consumed, sold, or discarded. The day the food is prepared or opened is day one.
3717-1-05.3(C) / Sewage and other liquid waste: Backflow prevention.
Critical Repeat Observed a direct connection between the sewage system and a drain originating from equipment in which food, portable equipment, or utensils are placed at time of inspection. The 3-compartment sink is used for food preparation without an air gap.
To prevent health hazards, install a food preparation sink with an air gap. Until a proper food preparation sink can be installed, ensure that a strainer is used to wash vegetables. A direct connection may not exist between the sewage system and a drain originating from equipment in which food, portable equipment, or utensils are placed unless allowed by the Ohio building code for: a warewashing machine between its waste outlet and a floor drain when the machine is located within five feet (1.5 meters) of a trapped floor drain and the machine outlet is connected to the inlet side of a properly vented floor drain trap; or a warewashing and culinary sink.

3717-1-04.8(A) / Equipment and utensils - air-drying required.
Repeat Equipment and utensils are not being air dried. Observed mugs used without air drying at time of inspection.
To ensure proper sanitization, air dry mugs after ware washing. After cleaning and sanitizing, equipment and utensils shall be air-dried or used after adequate draining before contact with food and utensils, and may not be cloth dried.
3717-1-05.1(I) / Service sink - number.
Repeat Observed no service sink (mop sink) or curbed cleaning facility as required at time of inspection.
To ensure proper cleaning and disposal, install a mop sink. At least one service sink or one curbed cleaning facility equipped with a floor drain shall be provided and conveniently located as specified in this rule.


Inspection Information


Facility Type: Seasonal Commercial FSO < 25000 sq. ft.

[?] Inspection Type: Standard

Inspection Date: 28-August-2018