I - P / Employee Health
The operation had an employee health policy on file.

II - P / Good Hygienic Practices
Food employee was demonstrating good hygiene practices.

III - P / Preventing Contamination by Hand
Food employees were not contacting exposed ready-to-eat foods with bare hands.

IV - P / Demonstration of Knowledge
The person in charge is Certified in Food Protection

V - P / Food from Approved Source
Foods are received from the following sources: Sysco and Produce One

VI / Time/Temperature Controlled Safety Food
Corrected During Inspection Observed cheese that was not date marked in the walk in cooler. PIC date marked it. Refrigerated, ready-to-eat, time/temperature controlled for safety foods held refrigerated for more than 24 hours were not properly date marked.
Refrigerated, ready-to-eat, time/temperature controlled for safety food held refrigerated for more than 24 hours shall be clearly marked at the time of preparation or the time the original container is opened to indicate the date or day to be consumed, sold, or discarded as required.
VI / Time/Temperature Controlled Safety Food
Corrected During Inspection Observed TCS foods (Cheese, milk, Ham salad, pasta salda) that were not discarded by the use by date. PIC discarded them. Ready-to-eat, time/temperature controlled for safety food that had been date marked was not properly discarded when required.
Refrigerated, ready-to-eat time/temperature controlled for safety food that has been prepared and/or opened in the facility, shall be discarded if it exceeds the temperature or date, or lacks a date, to limit the growth of pathogens to prevent foodborne illness.
VI - P / Time/Temperature Controlled Safety Food
Observed hot foods being held at 135°F or above; cold foods being held at 41°F or below.

VII - P / Protection from Contamination
Foods are protected from physical and environmental contamination during storage, preparation, holding and display.


Inspection Information


[?] Facility Type: Commercial FSO < 25000 sq. ft.

[?] Inspection Type: Critical Control Point

Inspection Date: 20-August-2018