3717-1-04.4(A)(2) / Equipment components kept intact, tight, and adjusted
Repeat Observed gaskets were replaced in both reach in cooler but not in the make tabke. PIC stated they received the wrong one and called the company to send them other gaskets that will fit the make table. PIC stated gaskets shall be replaced by 11/23.
Also observed the make table not holding food at the proper temperature. PIC emptied the cooler and will monitor it to see if it gets to temperature. If, not a work order will e put in. Equipment components are not intact, tight or properly adjusted.
[?] Facility Type: Commercial FSO < 25000 sq. ft.
[?] Inspection Type: Follow-up
Inspection Date: 25-November-2020
| The following violation(s) have been corrected since the last inspection. |
|---|
| 3717-1-05.1(C)(1)/Handwashing sink - required water temperature Observed handwashing sink in the kitchen, by the 3 bay and by the mop sink water below 100°F. |
| Comments |
|---|
| Facility was closed on 11/23 so follow up was done on 11/25. Hot water at the hand sinks was at required temperature. Make table in the kitchen was at 41F or below. PIC stated gasket for the make table was still not delivered. Confirmation of order will be sent. A reinspection will be done to ensure gasket has been replaced. |