< Previous Inspection ۸ Up to Facility Next Inspection >
[?] A summary of the violations found during the inspection are listed below.

3717-1-04.4(A)(2) / Equipment components kept intact, tight, and adjusted
Repeat Observed gaskets were replaced in both reach in cooler but not in the make tabke. PIC stated they received the wrong one and called the company to send them other gaskets that will fit the make table. PIC stated gaskets shall be replaced by 11/23. Also observed the make table not holding food at the proper temperature. PIC emptied the cooler and will monitor it to see if it gets to temperature. If, not a work order will e put in. Equipment components are not intact, tight or properly adjusted.


Inspection Information


[?] Facility Type: Commercial FSO < 25000 sq. ft.

[?] Inspection Type: Follow-up

Inspection Date: 02-December-2020


The following violation(s) have been corrected since the last inspection.
Comments
Talked to the owner on 12/01 and he stated gaskets ordered came wrong again. He stated he was going to get the gaskets at the store and rescheduled reinspection for 12/2. We talked on 12/2 and owner stated he went to purchase gaskets but was not able to get them because they were unavailable. Owner stated he put a new order in for the gaskets and is waiting to receive them. An invoice of the order was provided during inspection. Gaskets will be checked during the next scheduled inspection to see if they have been replaced.