No critical violations were documented at the time of inspection.
No violations were documented at the time of inspection.
Facility Type: Commercial FSO < 25000 sq. ft.
[?] Inspection Type: Follow-up
Inspection Date: 11-June-2016
| The following violation(s) have been corrected since the last inspection. |
|---|
| 3717-1-04.1(Y)/Temperature measuring devices. Cold or hot holding equipment did not contain a thermometer, or the thermometer was not correctly placed. The beer cooler does not have a thermometer. A properly designed temperature measuring device as specified in this rule shall be located in the warmest part of a cooling unit or the coolest part of a food warming unit. PLACE A THERMOMETER IN THE BEER COOLER. Correct By: 30-May-2016 |
| 3717-1-04.5(A)(3)/Cleanliness of nonfood-contact surfaces of equipment. Non-food contact surfaces of equipment are dirty. The inside of the cooler is dirty (in the oven room). The top of the oven is dirty. Nonfood-contact surfaces of equipment shall be kept clean. CLEAN IN THE COOLER AND THE TOP OF THE OVEN. Correct By: 30-May-2016 |
| 3717-1-05.1(C)(1)/Handwashing sink - required water temperature Observed a handwashing sink without water at the required temperature. The hot and cold water is not working at the bar hand sink. To ensure proper cleaning of hands, a handwashing sink shall be equipped to provide water at a temperature of at least 100° F (thirty-eight degrees Celsius) through a mixing valve or combination faucet. REPAIR HAND SINK WATER AT THE BAR. Correct By: 29-May-2016 |
| 3717-1-06.1(C)/Floor and wall junctures - coved, and enclosed or sealed. The floor and wall junctures are not properly coved or closed, or floor drains were not provided. Back oven room baseboard is coming off. In FSO's or RFE's in which cleaning methods other than water flushing are used for cleaning floors, the floor and wall junctures shall be coved and closed to no larger than one thirty-second inch; where water flush cleaning methods are used, shall be provided with drains and be graded to drain, and the floor and wall junctures shall be coved and sealed. Correct By: 30-May-2016 |
| 3717-1-06.4(A)/Repairing. The physical facilities are not being maintained in good repair. The walk in cooler floor is rusty, the trim in the bathrooms are not in place exposing seams. The physical facilities shall be maintained in good repair. PAINT WALK IN COOLER FLOOR. INSTALL THE TRIM IN THE BATHROOMS. Correct By: 30-May-2016 |
| 3717-1-06.4(A)/Repairing. The physical facilities are not being maintained in good repair. The ceiling is missing in the oven room. The physical facilities shall be maintained in good repair. INSTALL A CEILING IN THE FOOD OVEN ROOM. Correct By: 03-Jun-2016 |